- Save 15%
Universal Fan Control Ignitor Board 12V For Furnaces With Fan Control
Ignition Control Circuit Board; Replaces Dinosaurs Earlier Small And Large Fan Boards; Can Also Be Used To Replace The Present Fan Control Ignitor Boards Being Used By Suburban\ Atwood\ Hydroflame
When this board senses a “failure to ignite” or “loss of flame” condition it will wait one minute and shut the fan motor off instead of blowing cold air and maybe running the battery down. It replaces Dinosaur Electronics previous large and small Fan boards as well as the newer OEM Fan boards used in some furnaces. An LED on the board glows green when power is applied to the board and turns red when the board activates the gas valve.
The FAN 50 Plus Pins is designed to replace the new Suburban® and Atwood® / HydroFlame® Fan Control boards as well as maintain backward compatibility with the Fan 50 Plus, and UIB Fan Control boards which have been available since 1994. This board can also be used to upgrade older furnaces to add the Fan Control feature. The basic purpose of a Fan Control Ignitor Board is to shut the fan motor off if the board fails to sense a flame after the third ignition try. Thus, battery drain is reduced and the needless blowing of cold air is eliminated.
MFG# FAN50PLUSPINS UPC# 765053819152
No posts found